Hello,
Has anyone managed to do that?
Sivu 1 / 1
Hi,
After unpacking the Inteno DG301AL and connecting it, port 4 was in bridge mode.
Today Sonera decided to upgrade the FW on the box without giving any notice.
Now the same port seems to be NAT'd (I get a DHCP address to my computer (192.168.1.n))
Aki
After unpacking the Inteno DG301AL and connecting it, port 4 was in bridge mode.
Today Sonera decided to upgrade the FW on the box without giving any notice.
Now the same port seems to be NAT'd (I get a DHCP address to my computer (192.168.1.n))
Aki
Hi Johnny,
It is possible to set one port (ethernet port 4) to bidge mode. If you want this done, please contact our technical support, 0206 90101.
It is possible to set one port (ethernet port 4) to bidge mode. If you want this done, please contact our technical support, 0206 90101.
Hi akikoo,
What was your modems firmware before and what is it now? Is port 4 working in bridge mode now or do you want us to set it up again?
What was your modems firmware before and what is it now? Is port 4 working in bridge mode now or do you want us to set it up again?
When I first connected it, the FW was 10.4.x. On sunday connectivity was cut off and
once it came back, the FW was 10.5.x.
I can't check the status now because I lost the connectivity to home :(
Aki
once it came back, the FW was 10.5.x.
I can't check the status now because I lost the connectivity to home :(
Aki
Port 4 bridging works ok. In the future can you please send an e-mail or a SMS
before modem FW is updated?
Aki
before modem FW is updated?
Aki
Hi akikoo,
Good to know it's working now and thanks for the suggestion. I will send your suggestion forward.
Good to know it's working now and thanks for the suggestion. I will send your suggestion forward.
Vastaa
Rekisteröidy
Onko sinulla jo tili? Kirjaudu sisään
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.